600彩这是专业的

John Broskie's Guide to Tube Circuit Analysis & Design

600彩这是专业的08 october 2014

pre-rmaf ramblings

Pre-RMAF Ramblings
The Rocky Mountain Audio Festi looms before me. The RMAF is, as they like to put it, "the largest consumer audio and home entertainment show in the United States." A big audio show, in other words. Why it wasn't instead named "RMAS, the Rocky Mountain Audio Show" is a good question. (Perhaps, the Royal Military Academy Sandhurst or Royal Maritime Auxiliary Service wouldn't let them use their acronym.) I am glad that they left off the last four letters, "ival," stopping at "Rocky Mountain Audio Fest," as a fest is a gathering or an occasion characterized by a specified activity; and "festival" implies more celebration, more rejoicing than any audio show can deliver or that anyone could reasonably expect.

nonetheless, in two days, i will drive down to denver, colorado, through a mangled freeway of endless repairs, always changing speed limits, and guaranteed stop-and-go, halting progress. (this i know, as i made the exact same trip last weekend to the exact same location, but for non-audio reasons.)

At the show, I will wear my audio-press name tag, which confers a smidgen more attention from the exhibitors. But as my name tag will only state that I am the editor of the Tube CAD Journal, not a contributor to Stereophile or The Absolute Sound, I will not garner the apple-polishing, bootlicking, fawning, kowtowing, slavering, toadying displays of frenzied self-abasement—which is fine by me. Indeed, I know one audio-press personality, who wears his name tag backwards in its sleeve. On the other hand, this might not be the noble, reticent act that I imagine it to be, as all the press tags bear the same color, so by presenting the exhibitors its backside, he also presents them with an ambiguous proposition: Is he just some nobody blogger or a regular contributor to Stereophile or The Absolute Sound? Best not to take any chances they may conclude, so they crank up the sycophancy.

If you are wondering why I am writing about an event that has yet to materialize, do not worry, for there is a point, albeit an alternative-reality point. Let's imagine that I will be startled to see rows and rows of busses awaiting me at the RMAF; that I am told to get on board, as the show is being held elsewhere; that as I look out the bus's window, I am confused by our progress away from the big hotels and the cityscape, seeing upscale suburban houses instead; that the bus stops within a large new housing development and that we are told to explore the neighborhood; that I am given a map of the development, with each house labeled with a large audio company name, such as Acoustic Zen, Audio Note UK, Audio Research, Boulder Amplifiers…; that upon entering a large, modern house, I am pleased to see a high-end stereo system in the place of honor in the sparingly but nicely appointed living room; that as I sit upon the comfortable sofa I marvel at the silence between tracks, as no thumping sub-woofers can be heard leaking from other rooms; that, in fact, the loudspeakers and stereo gear now freed from the tight confines of a small, cheaply constructed hotel room, sound so good that the $70,000 price seems not too unreasonable; that after having enjoyed this acoustically-resplendent presentation, an audio oasis, I move to other rooms within the large house, where I find headphones and headphone amplifiers, cables, and other audio accessories on display; that the kitchen is filled with happy audiophiles, who sip wine and tell of their experiences; that the next house offers equal sonic wonders; that the fresh air and short walk outside perform an excellent audio reset, so my ears eagerly await the next house's auditory treasures; that I now—for the first time at any audio show I have attended—have a good idea what the stereo systems actually would sound like not in a crowded, noisy, elevator-sized room, but in my own living room... Dream on, John, dream on.

 

FETs and Aikido
My recent posts on hybrid power amplifiers, the ones that held a cascade of technologies: FET, vacuum tube, and then MOSFET or transistor output stages, prompted more interest in FETs than I expected. One reader asked if a FET-based buffer stage could be added to his existing Aikido line-stage amplifier. Now, the line that separates provocative, interesting questions from plain silly questions is indeed a thin one. My first impulse was, I am ashamed to say, was to place this question on the silly side of the divide, which was silly of me. The idea has real merit. How so? Well, if nothing else it would defend the volume control from the Aikido's input capacitance, which is relatively high, due to Miller-effect multiplication. The capacitance equals mu/2 times the grid-to-plate capacitance of the input triode.

one problem we face is supplying the fet with its own low-voltage power-supply rail. if you own a ps-15, there's no problem, as it offers two low-voltage, regulated power supplies, along with one high-voltage power supply. on the other hand, we could steal the low voltage from the high-voltage b+ connection.

a simple capacitance-multiplier circuit can be used, as shown above. the high-voltage transistor, say a tip50, must dissipate the lion share of heat, as it sees the lion share of voltage.

but now that we have introduced the transistor to the garden of eden, why not go all the way?

brace yourself, as there is much to cover here. first, note the bastode arrangement of the n-channel fet and the pnp transistor. as far as the fet is concerned, it is locked in a 20v vice; it can vary its current conduction and source voltage, but not its drain voltage. this varying current flow then travels through the pnp transistor down through the second rs resistor, which terminates into the negative power-supply rail. because the two rs resistors match each other's value, no gain is realized; indeed, there must be some slight loss in gain. the aikido then accepts the input signal and does its magic, but a bit differently than with a mono-polar power supply. for example, note the absence of the usual aikido two-resistor voltage divider that provides the bottom output triode with is sampling of the power-supply noise. where did it go? it wasn't needed, as the natural power-supply-noise null occurs at the output, as the bipolar power-supply rails hold equal, but opposite phase ripple, which when summed equal zero.

If we need more gain, we can make the bottom Rs resistor much larger in value than the top Rs resistor, for we have about 100 volts to play with. Why would we need more gain? Say you want to use this as the first stage in a phono preamp or you plan on following this circuit with a solid-state output stage, making a fine hybrid power amplifier.

Next Time
600彩这是专业的 The non-virtual RMAF, alas.

 

 

Since I am still getting e-mail asking how to buy these GlassWare software programs:
600彩这是专业的

600彩这是专业的for those of you who still have old computers running windows xp (32-bit) or any other windows 32-bit os, i have setup the download availability of my old old standards: , , and . the downloads are at the glassware-yahoo store and the price is only $9.95 for each program.

600彩这是专业的so many have asked that i had to do it.

WARNING: THESE THREE PROGRAMS WILL NOT RUN UNDER VISTA 64-Bit or WINDOWS 7 & 8 or any other 64-bit OS.

one day, i do plan on remaking all of these programs into 64-bit versions, but it will be a huge ordeal, as programming requires vast chunks of noise-free time, something very rare with children running about. ideally, i would love to come out with versions that run on ipads and android-os tablets.


600彩这是专业的

 

 

//jrb

   

 

Kit User Guide PDFs
600彩这是专业的 Click image to download

Janus regulator user guide

E-mail from GlassWare Customers

hi john,

I received the Aikido PCB today - thank you for the first rate shipping
600彩这是专业的 speed.

600彩这是专业的wanted to let you know that this is simply the best pcb i have had in my hands, bar none. the quality is fabulous, and your documentation is superb. i know you do this because you love audio, but i think your price of $39 is a bit of a giveaway! i'm sure you could charge double and still have happy customers.

600彩这是专业的looking forward to building the aikido, will send some comments when i'm done!

Thank you, regards,
600彩这是专业的 Gary.

And

Mr Broskie,
600彩这是专业的

i bought an aikido stereo linestage kit from you some days ago, and i received it just this monday. i have a few things to say about it. firstly, i'm extremely impressed at the quality of what i've been sent. in fact, this is the highest quality kit i've seen anywhere, of anything. i have no idea how you managed to fit all this stuff in under what i paid for it. second, your shipping was lightning-quick. just more satisfaction in the bag, there. i wish everyone did business like you.

Sean H.


High-quality, double-sided, extra thick, 2-oz traces, plated-through holes, dual sets of resistor pads and pads for two coupling capacitors. Stereo and mono, octal and 9-pin printed circuit boards available.

   Designed by John Broskie & Made in USA

aikido pcbs for as little as $24

 



Only $9.95
to start designing
tube-based crossovers
and much more...

The Tube CAD Journal's first companion program, TCJ Filter Design lets you design a filter or crossover (passive, OpAmp or tube) without having to check out thick textbooks from the library and without having to breakout the scientific calculator. This program's goal is to provide a quick and easy display not only of the frequency response, but also of the resistor and capacitor values for a passive and active filters and crossovers.

TCJ Filter Design is easy to use, but not lightweight, holding over 60 different filter topologies and up to four filter alignments:

        Bessel,
        Butterworth,
        Gaussian,
        Linkwitz-Riley.

While the program's main concern is active filters, solid-state and tube, it also does passive filters. In fact, it can be used to calculate passive crossovers for use with speakers by entering 8 ohms as the terminating resistance. Click on the image below to see the full screen capture.

Tube crossovers are a major part of this program; both buffered and un-buffered tube based filters along with mono-polar and bipolar power supply topologies are covered. Available on a CD-ROM and a downloadable version (4 Megabytes).

Download or CD ROM
Windows 95/98/Me/NT/2000/XP

 
hgyl285.cn           Copyright © 1999-2014 GlassWare           All Rights Reserved

 

2元就可以打1毛的炸金花棋牌 2元中国福利彩票的买法 2元就可以打1毛的斗地主棋牌 2元中国福利彩票怎么看 2元买彩票选几个数字 2元彩票 2元彩不错 2元彩是值得您信赖的 2元彩票网专家杀号排列三 2元彩票网体彩排列三